How to Attach Hardware Cloth to Raised Beds to Stop Gophers
Protecting your garden from burrowing pests requires a solid underground barrier, and this article provides a complete guide on securing hardware cloth to the bottom of your raised beds to stop gophers. You will learn the exact materials needed for the project, how to properly measure and cut the wire mesh, and the most effective methods for fastening it to both wooden and metal garden frames. By following these straightforward steps, you can create an impenetrable fortress that keeps destructive rodents out while allowing your plant roots and beneficial earthworms to thrive.
Gather the Right Materials
Before turning over your garden bed, assemble the necessary tools and supplies. Using the wrong mesh size or weak fasteners will allow gophers to push their way into your soil.
- Hardware Cloth: Choose 1/2-inch or 1/4-inch galvanized hardware cloth (at least 19-gauge). Avoid chicken wire, as gophers can easily chew through it or squeeze between the wider gaps.
- Fasteners: For wooden beds, use heavy-duty galvanized staples (at least 1/2-inch) or 1-inch exterior wood screws paired with fender washers. For metal beds, use self-tapping screws with washers.
- Tools: Tin snips or aviation shears for cutting the wire, a staple gun or hammer, a power drill, a tape measure, and heavy-duty work gloves to protect your hands from sharp wire edges.
Measure and Cut the Mesh
Flip your empty raised bed frame upside down so the bottom edges are facing up. Measure the length and width of the frame. Roll out the hardware cloth over the bottom of the bed.
Cut the hardware cloth using your tin snips so that it covers the entire opening and extends onto the bottom edges of the frame. Make sure the mesh does not hang over the outside edges of the bed, as the sharp wires will be exposed once you flip the bed back over.
Overlap for Wide Beds
If your raised bed is wider than the roll of hardware cloth, you will need to use two pieces. Overlap the two sections of mesh by at least 6 inches. Secure the overlapping sections together using galvanized bailing wire woven through the mesh every few inches. This prevents gophers from pushing through the gap between the two sheets.
Fasten the Hardware Cloth to Wood Beds
There are two primary ways to attach the mesh to a wooden frame:
- The Staple Method: Pull the hardware cloth taut across the frame. Using a heavy-duty staple gun or hammer-in poultry staples, secure the mesh to the bottom of the wood frame every 2 to 3 inches. Ensure the staples straddle the welded intersections of the wire for maximum hold.
- The Screw and Washer Method: For the strongest hold that prevents the wire from sagging under the weight of wet soil, use exterior screws and fender washers. Place a washer over the mesh and drive a screw through the center into the wood every 4 to 6 inches along the perimeter.
For extra durability, you can nail or screw an additional piece of 1x2 cedar or pressure-treated wood over the edges of the hardware cloth, sandwiching the wire between the bed frame and the trim.
Fasten the Hardware Cloth to Metal Beds
If you are using corrugated metal raised beds, you have two options:
- Direct Attachment: Drill self-tapping screws with wide washers directly through the mesh and into the bottom lip of the metal bed every 4 inches.
- The Fold-Up Method: If your metal bed does not have a bottom lip, cut the hardware cloth 6 inches wider and longer than the bed's dimensions. Place the mesh on the ground, set the metal bed on top of it, and fold the excess wire up the inside walls of the bed. Once you fill the bed with soil, the weight of the dirt will lock the mesh and the frame firmly in place.
Position and Fill the Bed
Once the hardware cloth is tightly secured, grab a helper and carefully flip the raised bed right-side up, placing it in its final location. Walk around the perimeter to ensure the frame sits completely flat on the ground. Fill the bed with your garden soil, and the weight will press the mesh firmly against the earth, completing your gopher-proof barrier.