How to Clean Sap and Rust Off Carbon Steel Shears

Carbon steel shears are prized by gardeners for their ability to hold a razor-sharp edge, yet they are highly susceptible to sticky plant sap and corrosion. This guide provides a straightforward, step-by-step process for cleaning your gardening tools after a long day of pruning. You will learn the exact household supplies needed to wash away dirt, dissolve stubborn tree resin, scrub away surface rust, and apply a protective oil coating to keep your carbon steel blades in pristine condition for years to come.

Supplies You Will Need

  • Warm water and mild dish soap
  • A stiff-bristled brush (like an old toothbrush or wire brush)
  • Rubbing alcohol (isopropyl), turpentine, or mineral spirits
  • Steel wool (0000 super-fine grade) or a baking soda paste
  • White vinegar (for heavy rust)
  • Clean, dry rags or paper towels
  • 3-in-1 household oil, camellia oil, or linseed oil

Step 1: Wipe Away Loose Dirt and Debris

Before addressing the sap and rust, remove regular garden grime. Run the blades under warm water and scrub them with a stiff brush and mild dish soap. This removes mud, dust, and plant matter that could get in the way of deeper cleaning. Dry the shears thoroughly with a clean towel immediately after rinsing so you do not introduce new rust to the carbon steel.

Step 2: Dissolve Sticky Sap and Resin

Water and soap will not remove sticky plant sap. Dampen a corner of a clean rag with rubbing alcohol, mineral spirits, or turpentine. Rub the affected areas of the blade vigorously. The solvent will break down the resin quickly. For exceptionally thick, hardened sap, let the alcohol sit on the blade for a minute before wiping it away. If you are trimming diseased plants, rubbing alcohol doubles as a disinfectant to prevent spreading pathogens to healthy plants later.

Step 3: Scrub Off Rust

Carbon steel oxidizes quickly when exposed to plant moisture. For light surface rust, take a piece of super-fine (0000) steel wool, dip it in a small amount of 3-in-1 oil, and scrub the rusted spots in small circular motions. The fine steel wool will lift the rust without scratching the metal.

If you want to avoid steel wool, mix baking soda with a little water to form a thick paste. Apply the paste to the rust and scrub it off using an old toothbrush or a crumpled piece of aluminum foil.

For heavy, neglected rust, submerge the metal blades in white vinegar for one to two hours. The acid in the vinegar will dissolve the iron oxide. Once removed from the vinegar, scrub the loosened rust off with a brush, rinse the blades with water, and dry them completely.

Step 4: Dry and Oil the Blades

Carbon steel must never be stored wet or bare. Once the sap and rust are gone and the tool is completely dry, apply a few drops of lubricating oil (such as camellia oil, linseed oil, or 3-in-1 oil) to the blades and the pivot joint. Wipe the oil across the entire metal surface using a clean rag. This leaves a microscopic barrier that blocks moisture and oxygen, preventing rust from forming while the shears are in storage. Open and close the shears a few times to work the oil into the hinge, wipe away any excess pooling, and store them in a dry place.